User's Manual

57
4.5.4 Volume Adjustments
To adjust the volume of inbound and outbound audio, customer greeter messages,
ceiling speaker and vehicle tones, or to schedule raising and lowering outbound audio
levels, on the base station LANE STATUS display, select Menu and then, on the MAIN
MENU select Volume adjust.
Press the button on the left side of the VOLUME MENU to select which volume you
want to adjust.
1. In/Out-bound Audio Volume
On the IN/OUTBOUND VOLUME display, select which volume you would like to
adjust, and then use the + and − buttons to raise and lower the volume level.
The first two settings adjust the audio level to and from the outside
speaker/microphone and the third setting adjusts the level of the outbound
Customer Greeter message from the Message Center. If a volume is set to 0, that
function is turned off and no audio is heard at all.
For dual-lane operations, these settings will be available for Lane 1 and Lane 2.
To automatically change the volume level of the outside speaker
(for example, to lower the volume at night), under Scheduled outbound, select
Schedules and then Settings as follows.
Note:
In multiple-lane
configurations, the
VOLUME MENU
display will be divided
by Lanes. Settings
will be similar to those
shown for single lane.
Note:
This Outbound audio level
will be active whenever any
scheduled outbound audio
level is not enabled.