User's Manual

7
Battery-release
latch
1.2.5 Battery Removal and Replacement
COM6000BP Belt-pac Batteries —
To change batteries:
If a battery is weak when the COMMUNICATOR
®
power is turned on, a voice in the earpiece will
say “Battery low.” If a battery becomes weak
during operation, a voice in the earpiece will say
“Change battery.” When this happens, take the
Communicator out of its pouch and slide the
battery-release latch in the direction of the
arrow. Pull up on the end of the battery near
the latch and lift it out of the Communicator, or
turn the Communicator over and catch the battery
in your hand.
To replace batteries:
Place the end of the battery with the metal contacts into the Communicator, in the
same position as the battery you removed. Press the top of the battery carefully
down into the Communicator until it snaps in place.
Odyssey IQ Headset Batteries —
To change batteries:
When a battery becomes weak, a voice in the Headset will say “Change battery.”
When this happens, remove the battery from the Headset by carefully sliding the
battery-release latch and lifting the battery out.
To replace batteries:
When replacing a battery in the Headset, place the end of the battery with the metal
contacts into the battery holder on the Headset, in the same position as the battery
you removed. Press the top of the battery carefully into the battery holder until it
snaps in place under the battery-release latch.
Recharge batteries according to the instructions on pages 9 and 10.
Figure 6.
Belt-pac battery-release latch
Battery-release
latch
Battery
Figure 7. Headset battery-release latch