User's Manual

16
 Remove the antenna from the antenna cable. DO NOT remove the antenna cable
from the base station.
 Unscrew the hexagonal nut from the antenna cable connector.
 Insert the antenna cable connector through the hole in the mounting bracket as
shown in Figure 14, and screw the hexagonal nut onto the connector to secure it in
place on the bracket.
Note: To minimize stress on the bracket, bend the cable to line it up with the bracket
before connecting it.
 Replace the antenna on the cable connector mounted on the wall.
Note: The best transmission and reception may be achieved with the antenna
perpendicular to the wall. However, if it is a safety hazard or is likely to be bumped
and damaged in that position, it may be necessary for the antenna to be parallel to
the wall.
 Return electrical power to the base station and resume normal operation.
CAUTION:
Use two wrenches
when tightening
nuts, to prevent
twisting and
damaging cable.
Hexagonal
nut
Lock
washer
Hole in
bracket
Male
antenna cable
connector
Hexagonal
nut
Antenna cable
Antenna
NOTE: The wall bracket
can be mounted as shown,
or in the reversed position,
with the hole for mounting
the antenna at the bottom.
Wall bracket
Antenna
connector
(screw type)
Figure 14. Remote antenna mounting on wall bracket