User's Manual

27
6.3 Single-Lane Operation
(one base station for one speaker post in one lane)
Hands-Free (HF) Mode:
 With the power off, press and hold the volume-up ▲ and B buttons while you press
and release the PWR button to turn the power on in the HF mode. The
COMMUNICATOR
®
will remember this setting.
 As a customer enters the drive-thru lane, you will hear an alert tone (single beep) in
your headset, and you will be able to hear the customer at the speaker post or
menu board.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Touch and release the A1 or A2 button to speak and listen to the customer.
 Touch and release the A1, A2 or B button to end communication with the customer.
 Touch and release the A1 or A2 button if you want to speak to the customer again.
 If a customer drives away from the speaker post or menu board, the Communicator
will stop transmitting.
Auto Hands-Free (AHF) Mode:
Note: Only one Communicator operator at a time can use the auto hands-free feature.
If a Communicator is turned off while in the AHF mode, it will automatically be reset
to its previous operating mode.
 With the power off, press and hold the volume-up ▲ and A1 buttons while you press
and release the PWR button to turn the power on in the AHF mode.
 As a customer enters the drive-thru lane, you will hear an alert tone (single beep) in
your headset, and you will be able to hear the customer at the speaker post or
menu board.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Speak and listen to the customer without pressing any buttons.
 Touch and release the A1, A2 or B button to end communication with the customer.
 Touch and release the A1 or A2 button if you want to speak to the customer again.
 If a customer drives away from the speaker post or menu board, the Communicator
will stop transmitting.
Push-To-Talk (PTT) Mode:
 With the power off, press and hold the volume-down ▼ and B buttons while you
press and release the PWR button to turn the power on in the PTT mode. The
Communicator will remember this setting.
 As a customer enters the drive-thru lane, you will hear an alert tone (single beep) in
your headset, and you will be able to hear the customer at the speaker post or
menu board.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Touch and hold the A1 or A2 button to speak to the customer. Release when
finished.