User's Manual

28
6.4 Dual-Lane Operation
(two base stations for two speaker posts in two lanes)
Hands-Free (HF) Mode:
 With the COMMUNICATOR
®
power off, press and hold the volume-up ▲ and B
buttons while you press and release the PWR button to turn the power on in the HF
mode. The Communicator will remember this setting.
 As a customer enters a drive-thru lane, you will hear an alert tone in your headset
(single beep for Lane 1, double beep for Lane 2), and you will be able to hear the
customer at the speaker post or menu board if that lane is selected.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Touch and release the A1 button for Lane 1 or A2 for Lane 2, to speak and listen to
the customer.
 Touch and release the A1, A2 (depending on lane) or B button to end communication
with the customer.
 Touch and release the A1 button for Lane 1 or A2 for Lane 2, to speak to the customer again.
 To change lanes, touch and release the opposite A button.
 If a customer drives away from the speaker post or menu board, the Communicator
will stop transmitting.
Auto Hands-Free (AHF) Mode:
Note: Only one Communicator operator at a time, in each lane, can use the AHF
feature. If an operator attempts to configure another Communicator, “System busy”
will be heard in his headset. Changing lanes is not possible in the AHF mode. If you
turn a Communicator off in the AHF mode, it will reset to its previous operating mode.
 For Lane 1 operation, with the power off, press and hold the volume-up ▲ and A1 buttons
while you press and release the PWR button to turn the power on in the AHF mode.
 For Lane 2 operation, with the power off, press and hold the volume-up ▲ and A2 buttons
while you press and release the PWR button to turn the power on in the AHF mode.
 As a customer enters a drive-thru lane, you will hear an alert tone in your headset
(single beep for Lane 1, double beep for Lane 2), and you will be able to hear the
customer at the speaker post or menu board if that lane is selected.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Speak and listen to the customer without pressing any buttons.
 Touch and release the A1, A2 (depending on lane) or B button to end
communication with the customer.
 Touch and release the A1 button for Lane 1 or A2 for Lane 2, to speak to the
customer again.
 If a customer drives away from the speaker post or menu board, the Communicator
will stop transmitting.
Push-To-Talk (PTT) Mode:
 With the Communicator power off, press and hold the volume-down ▼ and B
buttons while you press and release the PWR button to turn the power on in the
PTT mode. The Communicator will remember this setting.
 As a customer enters a drive-thru lane, you will hear an alert tone in your headset
(single beep for Lane 1, double beep for Lane 2), and you will be able to hear the
customer at the speaker post or menu board if that lane is selected.
 Use the volume-up ▲ and down ▼ buttons to adjust the customer’s voice level in
your headset if necessary.
 Touch and hold the A1 button to speak to a customer in Lane 1, or A2 to speak to a
customer in Lane 2.