User's Manual

31
6.7 Speed-Team Operation
Speed team operation is used during high-volume times. An order taker wearing a
Communicator relays orders from outside into the store, using button A1, A2 or B.
Note: Speed teams are not used in tandem drive-thrus.
6.8 Wired Backup System
In order to use a wired backup system, you must have a Switcher Board (optional) in
your base station. Open the base station, and look for the board shown in Figure 25.
If there is no Switcher Board, a wired backup system cannot be used. If there is a
Switcher Board, place the S2 switch in the IN position to use the wired backup
system. When using the Wireless IQ system, leave the S2 switch in the OUT position.
6.9 Message Repeater Operation
6.9.1 Recording Messages (Refer to Figure 2 on page 2.)
To record RED MESSAGE: RED MESSAGE switch must be in ON position.
Note: In Tandem base stations, the red message “Please pull forward” is pre-recorded.
Recording a new red message will replace the pre-recorded message.
 Press and release the RECORD MODE button on the base station once.
The red MESSAGE RECORD light on the base station will come on.
 Press and hold button B on the COMMUNICATOR
®
and talk into the headset
microphone to record a message (up to 15 seconds).
The MESSAGE RECORD light on the base station will begin blinking.
 Release button B.
The record function will stop and the MESSAGE RECORD light will go off.
To record GREEN MESSAGE: GREEN MESSAGE switch must be in ON position.
 Press and release the RECORD MODE button on the base station twice.
The green MESSAGE RECORD light on the base station will come on.
 Press and hold button B on the Communicator and talk into the headset
microphone to record a message (up to 15 seconds).
The MESSAGE RECORD light on the base station will begin blinking.
 Release button B.
The record function will stop and the MESSAGE RECORD light will go off.
Figure 25. S2 switch on Switcher Board