User's Manual

6.9.2 Message Repeater Switch Settings

Locate the ”RED MESSAGE” and “GREEN MESSAGE” switches, and the “RED

MESSAGE CONTROL” and “GREEN MESSAGE CONTROL” DIP switches inside the

front door of the base station for the following settings.

Note: If the RED MESSAGE and GREEN MESSAGE switches are both in the ON position,

and are selected for the same output, Red and Green Messages will be played alternately.

After a new message has been recorded or after the base station has lost and regained

power, any message to the outside speaker will always be heard in the Communicator

headset the first three times it plays, whether Switch 1 (DIP switch S13, 8) is in the ON

or OFF position. See Figure 28, page 37.

Red Message Switch:

In the ON position, the RED MESSAGE switch enables the “Red Message” to be

played. A playing message can be cancelled by pressing Communicator button A.

Note: The RED MESSAGE switch does not need to be in the ON position to enable the

“Red Message” to be played when the Tandem switch is on.

Red Message Control:

Switch 1 enables inbound audio from speaker post to be heard while message is playing.

Switch 2 enables message to be played to all Communicators.

Switch 3 enables message to be played on the outside speaker.

Switch 4 enables message to be played on the ceiling speaker.

Switch 5 causes message to be triggered by an external alert signal.

Switch 6 (only used in tandem systems, on secondary base station)

in OFF position, “Please pull forward” message plays once.

in ON position, “Please pull forward” message repeats every 4 seconds.

Switches 7 and 8 not used.

Green Message Switch:

In the ON position, the GREEN MESSAGE switch enables the “Green Message” to be

played. A playing message can be cancelled by pressing Communicator button A.

Green Message Control:

Switch 1 enables inbound audio from speaker post to be heard while message is playing.

Switch 2 enables message to be played to all Communicators.

Switch 3 enables message to be played on the outside speaker.

Switch 4 enables message to be played on the ceiling speaker.

Switch 5 causes message to be triggered by an external alert signal.

Switch 6 causes a 3 second delay before message is played.

Switch 7 not used

Switch 8 selects a “dual-beep” vehicle tone for the Lane 2 base station in a dual lane

configuration.