User's Guide
Table Of Contents
- 1 Important Safety instructions
- 2 Introduction to FreeSpeak Edge™
- 3 Installing FreeSpeak Edge
- 3.1 Installing the FreeSpeak Edge transceiver
- 3.2 Clear-Com cable recommendations
- 3.3 Daisy-chain transceivers
- 3.4 Installing and removing an E-IPA-HX card
- 3.5 Adding an E-IPA-HX card to the software
- 3.6 Configuring the E-IPA-HX card for FreeSpeak Edge
- 3.7 Beltpack roaming between E-IPA-HX cards
- 3.8 Connecting the FreeSpeak Edge transceivers to a matrix
- 3.9 Adding transceivers to the matrix
- 3.10 Beltpack roles
- 3.11 Registering the beltpack to a matrix
- 3.12 Connect the beltpacks
- 3.13 Radio Frequency (RF) channel selection and power settings
- 3.14 De-register beltpacks from a system
- 4 Site survey features
- 5 RF channel selection 5 GHz
- 5.1 Radio Frequency (RF) channel selection and power settings
- 5.2 Channel selection
- 5.3 Channel re-use
- 5.4 Using Dynamic Frequency Selection (DFS) channels
- 5.5 Radar scanning in DFS channels
- 5.6 Transceiver - excluded channels
- 5.7 Wireless Regulatory Region (WRR)
- 5.8 Change RF channels on the Edge transceiver
- 6 Operating the Edge beltpack
- 7 Operating the Edge transceiver
- 8 Upgrading FreeSpeak Edge
- 9 Specifications
- 10 Regulatory compliance
- 10.1 Part numbers and regulatory models
- 10.2 FCC notice
- 10.3 FCC/IC/EC RF exposure warning
- 10.4 Industry canada compliance statement
- 10.5 Korean notice
- 10.6 Japan notice
- 10.7 Australia compliance statement
- 10.8 New Zealand compliance statement
- 10.9 European Union (CE mark)
- 10.10 Waste Electrical and Electronic Equipment (WEEE)
- 10.11 General Battery Safety Instructions for Battery Models: BAT41, BAT50, BAT60, BAT70, BAT80
- 10.12 배터리 모델에 대한 일반 배터리 안전 지침 : BAT41, BAT50, BAT60, BAT70, BAT80
- 10.13 BAT41, BAT50, BAT60, BAT70, BAT80
FreeSpeak Edge | User Guide
User Restriction in the 5Ghz band: The device for the band 5150-5250MHz is only for indoor
usage to reduce potential for harmful interference to co-channel mobile satellite systems.
Jusqu’a nouvel ordre, les appareils faisant l’objet de la presente section ne doivent pas
transmettre dans la bande 5600-5650 MHz, afin que les radars meteorologiques
d’Environnement Canada fonctionnant dans cette bande soient proteges.
Until further notice, devices subject to this Section shall not be capable of transmitting in the
band 5600-5650MHz, so that environmental weather radars operating in this band are
protected.
10.5 Korean notice
A급 기기 (업무용 방송통신 기자재 )
이 기기는 업 무용(A급)으 로 전자 파적합기기 로
서 판매자 또 는 사용 자는 이 점을 주의하시 기
바라 며, 가정외의 지역 에서 사 용하 는 것을 목
적으 로 합니 다.
KCC 2.4Ghz and 5725-5850MHz warning: Life-related safety services cannot be provided
because the radio equipment may have radio interference.
해당 무선 설비는 전파혼신 가 능성이 있으 므로 인명 안전과 관련 된 서비스는 할 수 없음
10.6 Japan notice
電波法の規定により5GHz帯( W52、W53) は屋内使用に限ります。
User Restriction in the 5Ghz band: The 5Ghz bands (W52 and W53), which corresponds to
5150-5350Mhz, are restricted to indoor use only according to the provisions of the Radio Law
Warning: Under the Japanese Radio Equipment Category of Low Power Data Communications
System in the 5Ghz, the usage of U-NII-3 band (5745-5825Mhz) is not allowed.
10.7 Australia compliance statement
User Restriction in the 5Ghz band: This device is restricted to indoor use only when operating
in 5150-5350MHz.
Until further notice, devices subject to this Section shall not be capable of transmitting in the
band 5600-5650MHz, so that environmental weather radars operating in this band are
protected.
Page 89