User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
l
Reset to default from the Arcadia Central Station menu system: network setting are also
reset
l
Reset to default from the CCM: network settings are not reset
In either case, after resetting the device to default settings you will have to add all transceivers
back into the system using Hardware>Add Resource>Transceivers in the CCM. See Adding
IP Transceivers (FS Edge, FS II 1.9, 2.4) on page 54.
Note: When you use a pin reset on front the front of the Arcadia Central Station the device reboots.
2.9.1 Reset to default from the menu system
1.
Press the menu button on the front of the Arcadia Central Station.
2.
Using the rotary controllers navigate to Administration>Reset>Reset to Default>Reset
Base.
3.
Press the 4th rotary controller.
4.
The device will reset to factory defaults and reboot.
2.9.2 Reset to default from the CCM
1.
In the CCM, navigate to Status>>Overview>Host Device.
2.
Select Reset to Default.
3.
Reset to Default.
4.
The device will reset to factory defaults and reboot.
2.10 Example Applications
Here are some examples of typical installations.
2.10.1 Fast and Easy Setup: E1
The FreeSpeak II E1 transceivers use a proprietary E1 connection directly to the Arcadia
Central Station. The Core Configuration Manager (CCM) is the easiest way to configure your
system, but this set up does not require you to use it. This system can be configured from the
front panel menu system. In this example, using the default setup, all devices are talking and
listening to Channel 1 and Channel 2 and they can engage call signals to those channels.
Page 17