User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
6.1 Setting up the Arcadia Central Station
Click anywhere on the Hosts panel under Hardware > Resources to configure the Arcadia
Central Station.
Here you will configure:
l Network and IP
l Upgrade the Arcadia Central Station and connected resources
l Wireless beltpack system settings
l Administration pin numbers
l FS Edge wireless region (important for system compliance)
l FSII battery type, if you are not using the supplied Li-ion batteries you may use
Alkaline or NiMNH type batteries
l
Click the pencil icon to name your Arcadia Central Station
6.1.1 Network and IP
After changing the IP configuration, you must click Apply or [Enter] key.
For information see: Arcadia Central Station LAN Configuration Rules on page 38
Page 50