User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
l By USB cable (recommended). When registering a beltpack in this way, a role that
assignes keys to the beltpack is automatically created and fixed to the beltpack. The role
can be edited as required in the Configuration > Roles page of the CCM.
l Over The Air (OTA). When you register a beltpack in this way you must create a role for it
manually in Configuration > Roles before the beltpack can connect.
6.3.1 Registering a beltpack by USB cable
This method of registering beltpacks is recommended for fast and easy set up.
To register a beltpack using a USB cable:
1. Connect a beltpack to Edge Arcadia Central Station using a USB A to micro USB B (FSII) /
USB C (FSE) cable. The beltpack can be powered on either before or after connection. The
Arcadia Central Station will show 'Beltpack [ID] is now registered' in the front menu screens.
Note: When beltpacks are registered in this way, a role with two channels (A and B) is automatically
generated and applied to the beltpack. Roles can be edited at any time in the Configuration
page of the CCM.
6.3.2 Registering a beltpack OTA
To register a beltpack using OTA:
1. Navigate to Hardware > Resources and click Add Resource. The following screen
appears:
2.
Click Start OTA Registration.
Note: A timer is started indicating how long the system is open for registration. You can close OTA
registration on the system at any point.
Page 56