User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
l
FSII E1. Version , Label, Cable Comp.
8.1.7 Networking
Configure and view:
l
LAN Port Assignment
l
DHCP Enabled/Disabled
l
IP Address (read only when DHCP is Enabled)
l
Subnet Mask (read only when DHCP is Enabled)
l
MAC Address (read only)
Push the fourth rotary to open the on screen toucnscreen keyboard to change IP and Subnet.
[OK] when done. The keyboard is only available when DHCP is disabled.
Note: When changing from DHCP Enabled to DHCP Disabled, the address previously assigned by
the DHCP server will be set as the static address. This can cause IP conflicts so you must
change the address to one not provisioned by the DHCP server.
8.1.8 AES67 (for IP transceivers)
The section of the menu is read only and only shown if the AES67 connection has been
configured with a LAN port from the CCM. It shows:
l
LAN Port Assignment
l
DHCP Enabled/Disabled
l
IP Address
l
Subnet Mask
l
MAC Address
Note: When changing from DHCP Enabled to DHCP Disabled, the address previously assigned by
the DHCP server will be set as the static address. This is can cause IP conflicts, so you must
change the address to one not provisioned by the DHCP server.
8.1.9 Administration
l
Beltpacks
l
Over the Air: Press rotary four to Start OTA. Put the Arcadia Central Station in
pairing mode for OTA registration of beltpacks (600 seconds).
l
BP Role List Sorting:
Page 82