User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
Note: When resetting the base to default settings using the front panel menu system, all the system
configuration details, including network settings are reset. When resetting to default from the
CCM, the network settings are NOT reset.
Note: When you reset the Arcadia Central Station to default settings, you must Add the transceivers
to the system again. See Adding IP Transceivers (FS Edge, FS II 1.9, 2.4) on page 54
8.2.4 Reset the CCM password
1. Press the Menu button on the front of the Arcadia Central Station.
2. Using the right hand rotary controller select Administration > Reset > Reset CCM Pass.
3. Press the right hand rotary controller.
4. The password will reset to its default setting.
8.3 Key Behavior
Audio keys can be set to different Talk and Listen states. These key behavior states apply to the
keys on the Arcadia Central Station and beltpacks and panels. Key behavior is configured in the
Roles tab in the CCM. See Creating and Editing Roles on page 65section 6.7.3 Edit Role
Key Assignment.
Key
Behavior
Options
Resulting Audio Behavior
Talk-Only Press key to talk. Key only controls talk.
Listen-Only Press key to listen. Key only controls listen.
Talk and
Listen
Press key to talk and listen.
Dual Talk and
Listen
Press key to talk and listen. Listen latches on or off according to preference
(quick tap to latch). The user can push and hold (PTT) to activate talk.
Page 85