User's Manual

User Guide | FreeSpeak II™
Page 125
Figure 10-6 Beltpack systems
In order to connect the beltpack to the system, the system must be visible
(V) and in pairing mode (P) on the beltpack screen. If the system is not in
pairing mode, registration should be re-enabled.
Note: If a beltpack is connected to a system ‘C’ will be visible in this
screen. If a beltpack is not currently connected but has been in the
past ‘R’ will be visible. This shows that the beltpack has been
previously registered with the system which will recognize it.
5) Enter the four digit pairing code for the system using both rotary
controllers and the menu select key (D). The default code is 0000.
6) Select an available role from the list displayed on the beltpack.
7) The beltpack is now paired and ready for operation. The role is now
associated with the beltpack until association is removed using the
Configuration Editor or Base station.
8) If required, the next beltpack can now be registered (step 3). You may
need to re-enable registration mode before registering another beltpack.
Registration mode has a two minute inactive time-out.