User's Manual

User Guide | FreeSpeak II™
Page 131
 Vibrate & Audio - the beltpack vibrates and issues an audible alarm
 Vibrate only - the beltpack vibrates
 Audio only - the beltpack issues an audible alarm
 Off - the beltpack issues no alarms
Note: The factory default is Off.
Setting the out of range mode
Use this option to determine what kind of alarm the beltpack issues when it is no
longer within range of an antenna.
From the Out of Range Alarm list, select from the following options:
 Audio only - the beltpack issues an audible alarm
 Off - the beltpack issues no alarms
10.4.7 Setting the beltpack role options
Use this option to determine the beltpack role options.
Setting the display brightness
Use this option to adjust the display brightness.
 From the Display Brightness list, select a display brightness from 1 to 5.
Note: The factory default is 5.
Setting when the screen automatically dims
The beltpack display will dim if no key is used or there is no incoming call or call
alert after a certain timeout period. To determine the timeout period:
 From the Display Dim Timeout list, select a timeout period. The settings
run from Off to 120 seconds. The factory default is 30 seconds.
Setting when the screen automatically turns off
The beltpack display will turn off if no key is used or there is no incoming call or
call alert after a certain timeout period. To determine this threshold period:
 From the Display Off Timeout list, select a timeout period. The settings
run from Off to 120 seconds. The factory default is 30 seconds.
Setting when the listen again auto is automatically deleted
You can configure the beltpack to automatically record incoming audio to allow
you to replay the audio. These recordings are automatically deleted after a certain
period. To determine this period: