User's Manual

User Guide | FreeSpeak II™
Page 151
11 Upgrading the Base station from FS to FS II
This section explains how to upgrade a FreeSpeak/CellCom Base station to
FreeSpeak II using the Configuration Editor.
11.1 Setting the Base station IP address
1) Power up the Base station, and select SYSTEM > IP.
2) Enter the IP address for the Base station.
3) Reboot the Base station. The Base station is now configured for the new IP
address.
4) Install and start the Configuration Editor.
11.2 Upgrading the Base station firmware
1) From the Configuration Editor, click Send File, and ensure that the
correct Base station IP address is present.
2) Navigate to the location of the upgrade file.
Note: Make sure that the drop-down list in the lower right-hand corner of
the screen is set to Firmware files.
3) Click Open.
11.3 Upgrading the Base station FPGA
1) From the Configuration Editor, click Send File, and ensure that the
correct Base station IP address is present.
2) Navigate to the location of the upgrade file.
Note: Make sure that the drop-down list in the lower right-hand corner of
the screen is set to FPGA Files.