User's Manual

User Guide | FreeSpeak II™
Page 26
3) Available systems, and previously registered systems, will be visible on
the beltpack menu screen.
Figure 3-7 Beltpack systems
To connect the beltpack to the system, the system must be visible (V) and
in registration (pairing) mode (P) on the beltpack screen. If the system is
not in registration mode, registration should be re-enabled on the Base
station. (Step 1).
Note: If a beltpack is currently registered to a system ‘C’ will be visible in
this screen. If a beltpack is not currently registered but has been
in the past ‘R’ will be visible. This shows that the beltpack has
been previously registered with the system which might recognize
it.
4) Enter the four digit pairing code for the system using both rotary
controllers and the menu select key (D). The default code is 0000.
Note: The OTA registration code is available from the Base station menu.
Go to MENU->SYSTEM->REG->PIN. It can also be found in
Eclipse HX software, Configuration > Preferences > Wireless
Beltpacks and in the Configuration Editor, under the System tab.