User's Manual

User Guide | FreeSpeak II™
Page 54
6 Programming a system from the Base station
This chapter describes how to program the FreeSpeak II system using the Base
station front panel controls and menu. It contains the following sections:
 Introduction
 Using the Base station’s programming menus
 Saving changes
 Changing beltpack labels
 Setting and changing port labels
 Setting and changing group labels
 Adding group members
 Beltpacks
 Assigning audio routes to a beltpack
 Setting the beltpack audio level
 Setting beltpack latching
 Over the Air (OTA) beltpack registration from the Base station
 Setting input and output port levels
 Setting port call destination
 Configuring a wired partyline
 Base station System Menu
 System
 Restoring the Defaults
 Antennas
 Setting the IP address
 Locking front-panel enable buttons
 Remote microphone kill
 Battery indicator