User's Manual

User Guide | FreeSpeak II™
Page 65
Figure 6-18 Select the source/destination to assign to that beltpack key
6) Scroll through the list and select the desired source or destination to
assign to that beltpack key. A box appears around the selection and the
next screen appears for assigning the key type.
7) For some destinations and sources (headsets, stage and program
announce, beltpacks and IFB’s) the system will assign the feed to the
beltpack key when you press the setup/Enter rotary controller. You will be
returned to the previous screen and it will flash to show a change has
been accepted by the system.
For other audio routes (4 wire ports, groups and wireless partylines) it will
be necessary to select a key assignment type. See step 8 below.
8) Select either talk (TLK), listen (LIS), talk/listen (T+L), dual talk/listen
(DTL), forced listen (FL) or talk/forced listen (TFL) for that key.
Figure 6-19 Key type menu
Note: For more information on audio route key types see 10.4.10 Key Assignment
Types.
9) The display automatically returns to the screen for selecting the next key
to program.
10) Select the next key and follow steps 4 through 6. Continue until sources
and destinations have been assigned to all desired keys on that beltpack.
Note: Keys C & D default to call keys for A & B respectively if not assigned.
To assign keys for another beltpack continue selecting the BACK command on
each successive screen until reaching the AVAILABLE BELTPACKS menu. Highlight
and select the next beltpack, and repeat the above procedures.
11) The screen will flash after a change has been made to show that it has
been accepted by the system.