User's Manual
User Guide | FreeSpeak II™
Page 7
8.6 Configuring the beltpack alarm options .......................... 101
8.6.1 Setting the low battery alarm ......................................... 101
8.6.2 Setting the low battery alarm threshold ............................ 102
8.6.3 Setting the out of range alarm ........................................ 102
8.6.4 Setting the call alert ...................................................... 102
8.7 Selecting the beltpack role default set ........................... 103
8.8 Selecting the beltpack administration ............................ 103
8.8.1 Enabling OTA registration mode ...................................... 103
8.8.2 Setting full menu access ................................................ 104
8.8.3 Setting system sync mode .............................................. 105
8.9 Setting the listen again option ...................................... 105
8.10 Accessing beltpack information ..................................... 105
8.11 Setting display mode .................................................. 106
8.12 Setting system connect ............................................... 106
8.13 Enabling over the air (OTA) registration mode from a
beltpack .................................................................... 107
8.14 Performing a site survey .............................................. 107
9 Operating the transceiver/antenna .......................... 109
9.1 Transceiver/antenna ................................................... 109
9.1.1 IP rating (International Protection Marking) ...................... 109
9.1.2 FS II transceiver/antenna connector panel ........................ 110
9.1.3 Cabling the antennas ..................................................... 111
9.1.4 Beltpack support capacities for transceiver/antennas .......... 111
9.1.5 Coverage areas under various conditions .......................... 112
9.1.6 Transceiver/antenna setup rules and tips .......................... 112
9.1.7 Upgrading the antenna/transceiver firmware ..................... 113
9.2 Transceiver/antenna splitter (PD2203) .......................... 113
9.2.1 PD2203 Front connector panel ........................................ 114
9.2.2 PD2203 rear panel ........................................................ 115
9.2.3 Connecting an antenna splitter to the FS II Base station and to
transceiver/antennas ..................................................... 116
10
FS II Configuration Editor
........................................ 117
10.1 Loading configurations ................................................ 118