User's Manual

User Guide | FreeSpeak II™
Page 70
1) From the MAIN menu, select ‘PORTS’. A menu of the available audio ports
is displayed.
Figure 6-29 Available audio ports menu
2) Select the port for which the call destination is to be set (excludes headset
ports). The menu for the selected port will be displayed.
Figure 6-30 Selected port menu for calls
3) Select ‘CALLS’ from the menu. The call destination menu will be displayed.
Figure 6-31 Port call menu
4) Use the setup/enter encoder to scroll through the available ports and
select the required destination port. It is possible to select the source port
as the call destination to create an audio loopback system. This may be
used for audio testing purposes.
Figure 6-32 Port destination select menu
5) When the port is selected, the user is returned to Selected Port Menu
for Calls (Step 2). The screen will flash momentarily to indicate that the
port change has been accepted by the system.
6) The port destination can be cleared by repeating the process and selecting
the ‘NONE’ entry.
If one of the headset ports (HDSTA, HDSTB) is selected the port menu is different
in that ‘KEY’ is displayed rather than ‘CALL’. This indicates than in order to trigger