User's Manual

User Guide | FreeSpeak II™
Page 93
From the Configuration Editor, you can upgrade the beltpack firmware using a
USB connection or central upgrade Over The Air (OTA).
Note: If you have a matrix connection, you can also do an Over The Air upgrade. For
more information, see the Eclipse HX Configuration Software User Guide.
7.3.7.1 Upgrading using a USB connection.
1) Connect the beltpack to a USB port on the computer running the
Configuration Editor.
2) Select Diagnostics > Tools > Apply Wireless Firmware Via USB.
3) Browse to the location of the upgrade file (.FWS), and then select Update
Firmware.
The upgrade file is downloaded to the beltpack.
Note: You can connect more than one beltpack to the computer if you have multiple
USB ports. The units will be upgraded sequentially.
7.3.7.2 Upgrading by Over The Air Upgrade
1) From the Configuration Editor, Select Send File, and then browse to the
location of the upgrade file (.FWW).
2) Select Open. The download will begin. The beltpacks will be disconnected
while the download file is loaded onto the antennas.
The beltpacks will only be upgraded, when the download file has
successfully loaded on all the connected antennas.
Note: The Base station front panel will display a download progress
screen.
3) To cancel the download, press Enter on the Base station.