User's Manual

User Guide | FreeSpeak II™
Page 94
8 Programming on the beltpack
This chapter explains how to program the beltpack using the beltpack's menu
system. It contains the following sections:
 Introduction to programming on the beltpack
 Configuring the beltpack volume settings
 Configuring the beltpack headset
 Configuring the beltpack microphone
 Configuring the beltpack display
 Configuring the beltpack alarm options
 Selecting the beltpack role default set
 Selecting the beltpack administration
 Setting the listen again option
 Accessing beltpack information
 Setting display mode
 Setting system connect
 Enabling over the air (OTA) registration mode from a beltpack
 Performing a site survey
8.1 Introduction to programming on the beltpack
You can access the beltpack menu by pressing and holding the menu key. The
Master Menu screen is displayed. This consists of the following submenus:
 Volume Level Control
 Volume Operation
 Line In Volume Level
 Settings
 Information
 Display Mode
 System Connect
 Site Survey
Note: The menus that appear depend on the menu access level. See 8.8.2 Setting full
menu access.