User Manual

13
Configuration displays provide customized configuration settings for the base station and beltpacs. They also
allow you to save your settings to a file for future access. Advanced settings are provided for output mixing, alert
signals and paging capabilities. Beltpac ID name and number settings made at the main base station can be
synchronized in added slave base stations via the Configuration, Sync Bases display.
Base Station Transmitter Power:
Select transmitter 1 or 2, then press the ENTER
button.
At the power level box, select 1, 10, 100 or
250mW, then press ENTER. To change the
Off/On status of the transmitter, select the Off or
On button, then press ENTER.
Base Station Transmitter Frequency:
Frequencies P1 – P4, S1 – S4 and T1 – T4 are
preset in the system and cannot be changed.
Frequencies U1 – U5 can be set by the user.
Select transmitter TX1 or TX2, then select a
frequency for that transmitter. If you select a user
frequency, U1 – U5, move the cursor to the
frequency box and use the up and down arrow
buttons together with the control knob to select a
frequency. User frequencies can be selected in
25kHz increments.
NOTE: Frequencies within the same group
(P, S or T) are compatible with each other and free
of intermodulation.
Base Station Transmitter Mix Levels:
Select transmitter 1 or 2, then press the ENTER
button.
Use the left arrow button to select the Tx box,
then use the control knob to adjust the transmitter
master level in 1.5dB increments.
Select the box next to IC1, IC2 and Aux to enable
that input in the output mix. Mic is a standard
output.
Place the cursor to the left of any slider bar and use
the control knob to adjust each output level in
increments of .25dB (fine) or 2.25dB (coarse).