User Manual

25
Information displays provide information about the base station and its current configuration settings file, and
testing capability for transmitter and receiver sub carriers.
The file number displayed is for current
configuration settings. It was the settings file
being used the last time the base station was
turned off, or the last settings file you saved since
the base station was turned on.
This is the file that will be used next time the base
station power is turned on.
Base station software version number and date
are displayed.
DSP software version number is displayed.
To perform a sub carrier transmitter test, with
the curser at the BP box, enter a beltpac ID
number then select Start. Let the test run for a
few seconds then press the ENTER button to stop
it. The results will be shown at the right side of
the display.
NOTE: The beltpac must be turned on and set to
the PTT or PTE transmit mode.
Press the beltpac C and D buttons on a beltpac
simultaneously. To perform a sub carrier
receiver test, select Start then press the ENTER
button.