User's Manual

10
E. Message Repeater Operation
ACTION RESULT
Press and release the RECORD MODE
button on the base station once.
The red MESSAGE RECORD light
on the base station will come on.
Press and hold button B on the headset
and talk into the headset microphone to
record a message (up to 8 seconds).
The MESSAGE RECORD light on the
base station will begin blinking.
To record
Message #1
Release button B. The record function will stop and the
MESSAGE RECORD light will go off.
Press and release the RECORD MODE
button on the base station twice.
The green MESSAGE RECORD light
on the base station will come on.
Press and hold button B on the headset
and talk into the headset microphone to
record a message (up to 8 seconds).
The MESSAGE RECORD light on the
base station will begin blinking.
To record
Message #2
Release button B. The record function will stop and the
MESSAGE RECORD light will go off.
Locate the “RED MESSAGE CONTROL” and “GREEN MESSAGE CONTROL” DIP switches inside the
front door of the base station for the following settings.
Red Message
• “RED MESSAGE” switch in the ON position enables the “RED MESSAGE” to be played.
• will be triggered by a vehicle present signal if “RED MESSAGE CONTROL” switch #5 is in the OFF
position. The playing message can be cancelled by pressing Communicator button A.
• will be triggered by alert signals if “RED MESSAGE CONTROL” switch #5 is in the ON position.
• will be played to the locations selected if “RED MESSAGE CONTROL” switches 2, 3 and/or 4
are in the ON position.
Switch 1 enables message to be played back with inbound on.
Switch 2 enables message to be played back in all COM6000BP Communicators.
Switch 3 enables message to be played back on the outside speaker.
Switch 4 enables message to be played back on the ceiling speaker.
Switch 5 causes message to be triggered by an alert signal.
Green Message
• “GREEN MESSAGE” switch in the ON position enables the “GREEN MESSAGE” to be played.
• will be triggered by a vehicle present signal if “GREEN MESSAGE CONTROL” switch #5 is in the
OFF position. The playing message can be cancelled by pressing Communicator button A.
• will be triggered by alert signals if “GREEN MESSAGE CONTROL” switch #5 is in the ON position.
• will be played to the locations selected if “GREEN MESSAGE CONTROL” switches 2, 3 and/or
4 are in the ON position.
Switch 1 enables message to be played back with inbound on.
Switch 2 enables message to be played back in all COM6000BP Communicators.
Switch 3 enables message to be played back on the outside speaker.
Switch 4
enables message to be played back on the ceiling speaker.
Switch 5 causes message to be triggered by an alert signal.
Switch 6 causes a 3 second delay before message is played back.
Switch 8 allows selection of a single-beep alert tone or two short beeps.
If both RED and GREEN MESSAGE switches are in the ON position, Red Message and
Green Message will be played alternately.
After a new message has been recorded or after the base station has lost and regained
power, any message to the outside speaker will always be heard in the headset the first
three times it plays.