User's Manual

2
Headset Registration
Each HS6100 Headset must be registered for use with a specific base station. The base station thereby
recognizes all headsets registered to it when their power is on, and will be able to tell
the difference between
them and other electronic equipment operating on similar frequencies. A maximum of 15 headsets can be
registered. If one is replaced, you must register the new one before you use it. When a headset is replaced,
the old one remains in memory.
Register all active HS6100s the same way, one at a time.
NOTE: Headsets must be within 6 feet (1.83 meters) of the base station while being registered.
Figure 3. Wireless IQ™ and ionIQ™ base stations
If your base station looks like this If your base station looks like this
see
registration instructions below see registration instructions on page 3
Wireless IQ
™
base station ionIQ
™
base station
For Wireless IQ
™
Audio Systems, Register each Headset as follows:
NOTE: If the maximum number of 15 is exceeded, an “F” for Full will appear on the Communicator ID
display. You must clear all current registrations and re-register all active headsets. Refer to Figure 4.
Open the base station and press the CLEAR ALL REGISTRATION button and the RESET button at the
same time. Continue holding the CLEAR ALL REGISTRATION button after releasing the RESET
button, until “c” appears on the display.
• Be certain all headsets to be registered are turned off and the base station power is on. Other
headsets can be on or off.
• Open the base station and locate the items shown in Figure 4.
⎯ If no headsets are on, the status light will be blinking red. If any headsets are on, the status
light will be on steady green.
⎯ Press the START REGISTRATION button. The Communicator ID display will show a small
“o” for open, and the status light will be blinking green.
•
Either press and hold the B button on the headset while pressing and releasing the power button
to turn the headset on, and then release the B button,
or press the power button and hold it for
approximately 10 seconds. This will cause the headset to enter the registration mode.
⎯ The status light in the base station will be blinking green and the Communicator ID display will
continue to show a small “o” for open.
⎯ The headset power light will be blinking amber.
When the registration is
successfully completed:
RESET button
CLEAR ALL REGISTRATION button
START REGISTRATION button
Status light
K1 switch
Communicator ID display
• The green status light in the base
station will be on steady and the
Communicator ID display will show
the ID number assigned to this headset.
ID numbers are assigned sequentially
as 0 thru 9, A, b, C, d and E.
• The power light on the headset will
remain on steady green.
Figure 4. Registration buttons and indicators in base station
If registration failed:
• A message in the headset will say “Beltpac #, Battery Low/Half/Full, Registration …” The power
light will blink red and after a delay of up to 1.5 minutes you will hear “Registration failed.”
• Note the condition of the STATUS light in the base station. Press the RESET button. The STATUS
light may blink and change colors. When the STATUS light returns to its previous condition, press
the START REGISTRATION button and repeat the registration procedure.
• If the registration fails again - In the USA call HME Customer Support at 1-800-848-4468.
Outside the USA, call your local HME representative for help.