Owner manual

DECLARATION OF CONFORMITY

KOLVER S.r.l.

VIA MARCO CORNER, 19/21

36016 THIENE (VI) ITALIA

Declare that the new tool here described:

Electric screwdriver:

FAB03SS/FR 110003/FR  FAB10RE/FR 110010/FR 

FAB12RE/FR 110012/FR  FAB12PP/FR 110013/FR 

FAB12PP/U/FR 110013/U/FR  FAB12PS/FR 112012/FR 

FAB18RE/FR 110618/FR  FAB18PP/FR 110619/FR 

FAB18PP/U/FR 110619/U/FR  FAB18PS/FR 112618/FR 

Is in conformity with the following standards documents:

98/37/CE, 89/336/CE and 2006/95/CE, 93/68,

and the normative: EN 50144-1 and EN 60204-1

Name: Giovanni Colasante

Position: Managing Director

Giovanni Colasante

KOLVER S.r.l.

Operator’s Handbook

IDENTIFICATION DATA OF THE MANUFACTURER

KOLVER S.r.l.

VIA MARCO CORNER, 19/21

36016 THIENE (VI) ITALIA

IDENTIFICATION DATA OF THE PRODUCT

ELECTRIC SCREWDRIVER MODEL:

FAB03SS/FR 110003/FR  FAB10RE/FR 110010/FR 

FAB12RE/FR 110012/FR  FAB12PP/FR 110013/FR 

FAB12PP/U/FR 110013/U/FR  FAB12PS/FR 112012/FR 

FAB18RE/FR 110618/FR  FAB18PP/FR 110619/FR 

FAB18PP/U/FR 110619/U/FR  FAB18PS/FR 112618/FR 

THECNICAL DATA OF THE PRODUCT

TENSION: 30V DC

POWER: 30W

SPEED RPM: FAB10/FAB12:1000 – FAB03/FAB18:650

TORQUE RANGE Nm: FAB03:0,05-0,3 / FAB10:0,05-0,8

FAB12:0,2-1,2 / FAB18:0,3-1,8

Documentation Provided By HMC Electronics

33 Springdale Ave. Canton, MA 02021

http://www.hmcelectronics.com

(800) 482-4440

PAGE 1
DECLARATION OF CONFORMITY Operator’s Handbook KOLVER S.r.l. VIA MARCO CORNER, 19/21 36016 THIENE (VI) ITALIA IDENTIFICATION DATA OF THE MANUFACTURER KOLVER S.r.l.
PAGE 2
GENERAL SAFETY RULES WARNING: when using electric screwdrivers, basic safety precaution should always be followed to reduce the risk of fire, electric shock and personal injury. Read all the instructions below before using the screwdriver and save them. 1. Keep the work area clean and well lit. 2. Do not use the electric screwdrivers in dampt or wet locations or in presence of flammable liquid or gases. 3. Avoid body contact with grounder surface as pipes, radiator, refrigerators, etc. 4.
PAGE 3
The tool is equipped with an extra spring to reach the lower torque values. To change the spring remove #2 nut, replace the spring and then adjust the torque value as mentioned above. To check the torque value we suggest the use of K5 electronic torque tester. 5. Maintenance The screwdriver’s motor is equipped with carbon brushes 9mm long. When their lenght is about 5mm it is time to replace them as per the following instructions: a. Remove the #59 and #68 screws and the #54 and #58 housings. b.