Instruction manual

FCC Disclaimer:
One Year Limited Warranty:
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules and Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation. The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment. Under Industry Canada regulations, this
radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
For detailed Warranty Instructions and Information visit:
http://www.hmdxaudio.com/products/jam-wireless-portable-speaker.html
To obtain warranty service on your HMDX product, contact a
Consumer Relations Representative by telephone at 1-800-753-3000
or email [e-mail] for assistance. Please make sure
to have the model number of the product available. Representatives
are available 8:30am - 7:00pm EST Monday-Friday.
Por manual de instrucciones e Información de garantía en español visítenos
en www.hmdxaudio.com
HMDX Jam and HMDX are trademarks of HMDX.
©2012-2013 HMDX. All Rights Reserved.
IB-HXP230C
Only use a soft dry cloth to clean the enclosure of the unit.
NEVER use liquids or abrasive cleaner to clean.
Maintenance
IMPORTANT SAFEGUARDS:
When using an electrical product, basic precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING
• WARNING: Do not place speakers too close to ears. May cause damage to ear
drums, especially in young children.
• Use this product only for its intended use as described in this manual. Do not
use attachments not recommended by HMDX.
• HMDX is not liable for any damage caused to Smartphones, iPod/MP3 player or
any other device.
• Do not place or store this product where it can fall or be dropped into a tub or
sink.
• Do not place or drop into water or any other liquid.
• Not for use by children. THIS IS NOT A TOY.
• Never operate this product if it has a damaged cord, plug, cable or housing.
• Keep away from heated surfaces.
• Only set on dry surfaces. Do not place on surface wet from water or cleaning
solvents.
1. Connect Aux-in cable to the headphone or line-out jack of an
audio device and plug the other end of the cable into the
Line-In Audio Jack on the back of the unit.
2. Slide the POWER SWITCH to turn on the unit.
3. Press PLAY on the device and use controls on the unit to adjust
desired volume.
NOTE: Play/pause controls on the unit will not work when using the
line-in audio jack.
Listening to your device through
the Auxiliary Line-In Audio Jack