Operation Manual

ENGLISH

Manually transfer Not Sent data

You can also manually trigger data transfer to the receiving device. To do so, you rst

have to turn on SEND mode on your smartLAB

walk P+ device.

Please quickly press and release the “Disp/ Set” button, and then press it again for 6

seconds. In the upper display area “SEnd” appears.

If you now press „M/” the display will show “picture 7”.

By pressing “Disp/ Set” again, you will manually trigger the data, which has not been

sent yet, transfer. The symbol for wireless data transfer will ash in the display.

If the data transfer was successful, you will see “picture 9”; if the data transfer could

not be completed, “picture 10” will appear on display. In case no connection at all

can be established, the display will show “picture 11”.

pict. 7