Operation Manual

36
Manually transfer all data
You can also manually trigger all data transfer to the receiving device. To do so, you
rst have to turn on Send mode on your smartLAB
®
walk P+ device.
Please quickly press and release the “Disp/ Set” button, and then press it again for 6
seconds. In the upper display area “SEnd” appears.
If you now press „M/” twice the display will show “picture 8”.
By pressing “Disp/ Set” again, you will manually trigger the all data transfer. The
symbol for wireless data transfer will ash in the display. If the data transfer was
successful, you will see “picture 09”; if the data transfer could not be completed,
“picture 10” will appear on display. In case no connection at all can be established,
the display will show “picture 11”.
pict. 8