User's Guide

Packing list Download and Install HNK APP
Product Appearance
Mesh x 3
Power Adapter x 3
Lan Cable x 1
QIG x 1
1
Setup the first node
2
Scan the QR code below to download and install
the HNK APP on your phone
1. Connect one end of the network cable to a modem or
broadband network port, and the other end connects any
WAN/LAN port.
2. Connect the node to power, and the indicator light is
steady green. After about 40 seconds, the LED light flashes
green and the system startup is complete.
Setup the first node WiFi connection.
3
1.Connect the mobile with the first WiFi internet.
WiFi Name, password can be found at the bottom
sticker of the node.
Setup the first node wireless connection
4
Setup the first node wireless connection
1.For a better wireless Internet experience, please refer to the
following suggestions to put other nodes in the proper
position.
• Do not exceed two walls between a node and another node
• Keep away from microwave ovens, induction cookers, and
refrigerators
• Higher distance from ground and less obstructions around
2.Power on the node, the indicator light is steady green, and
the system finishes start after 40 seconds successfully. The
indicator flashes green, and starts to look for another node
to connect.indicator light flashes green, and it starts to find
another node to connect.
3.Continue to observe the indicator light until it
changes from flashing green to the following state:
4.If the node LED is not steady green on, please refer
to suggestion places (first step of Step four). Replace
the nodes for best wireless connection quality.
Finish installation
●Wired device internet connection: please connect
with the LAN port of the node.
●Wireless device internet connection: please reconnect
with new wireless internet (all nodes’ WiFi name/-
password are the same)
●If you want to remotely control the internect, please
access by APP,and login by account to manage.
2.Open HNK APP, and connect the first node to the
internet according the interface guide. When the
mode LED is always blue on, the node connects
with the internet successfully.
Power ResetLAN1 LAN2 WAN
ResetLAN1 LAN2 WAN
Internet
Indicator light
Green always on
Green slow flash
Green fast flash
wireless connection good
wireless connection normal
wireless connection weak
Red always on wireless connection failure
WAN Port
Modem
or
Step One Step Two
WiFi LAN Internet
WiFi LAN Internet
Select Internet...
Set up
HNK-XXXXXX
XXXXXX
Scan the QR code to download
Or use the mobile browser and enter the url: https://fir.im/mlsa
Updated on: