Instruction DISHWASHERSML-38898 ML-38899 ML-104047 ML-104050 C44AW ML-103946 ML-103947 ML-104082 ML-104083 C54A ML-104199 ML-104198 C64A ML-103908 ML-103909 C88A ML-110042 ML-110041 CRS66A ML-38947 ML-38948 ML-104052 ML-104055 CRS66AW ML-103958 ML-103959 ML-104086 ML-104087 CRS76A ML-104202 ML-104201 CRS86A ML-103910 ML-103911 CRS110A ML-110044 ML-110043 CCS66A ML-104321 ML-104320 CCS66AW ML-104323 ML-104322 CCS76A ML-104325 ML-104324 CCS86A ML-104327 ML-104326 CCS110A ML-110046 ML-110045 CPW80A ML-3

– 20 –
OPERATION
PREPARATION
Put the dishwasher strainer pans and strainer basket (Fig. 3) into position in each dishwasher tank.
If the machine is equipped with an RS, CS, or PW unit, install the solid prewash strainer pan over the
overflow tube, flange side down and the lip toward the rear of the tank. Install one perforated strainer
pan, handle side up, across the rear of the tank. Install the other perforated strainer pan against the load
end of the tank and locate the flange into the notches on the solid and perforated strainer pans. Drop
in the perforated strainer basket (Fig. 11).
Fig. 11 Fig. 12
Hang curtains on open hooks provided. Refer to Curtain Installation.
Move drain lever(s) down to close the drain(s) (Fig. 12), or close the door(s) to automatically push the
lever(s) down.
FILLING THE DISHWASHER
Water must be proper hardness. Recommended hardness range is 4 to 6 grains/gallon.
Turn the Power switch ON (Fig. 1). Leave pumps OFF until machine has completely filled.
If the machine is equipped with an RS, CS or PW unit, the prewash tank will fill last, with overflow
water from the wash tank.
If the machine is equipped with steam heat, the mechanical ball valve (located between the drive motor
and the tank) must be opened by pulling the valve lever down.