Operation ELECTRONIC OVEN HBA2G, HBA2E

– 12 –
Control Guide - Advanced (cont)
Button Action Display
Press to stop the BAKE The ON light is off when the BAKE TIMER is inactive.
TIMER or silence the
beeper after the BAKE
TIMER has timed out.
PROGRAM Press to select bake The PROGRAM window displays the number of the
program. current program.
STEP Press to select one of The corresponding indicator light will be lit (1 to 4),
four baking steps. depending on which step is selected.
Press to open or The indicator light above the VENT button is lit when the
close the vent. vent cycle is enabled.
Auto On/Off Timer
Timer Settings
The Auto ON/OFF Timer display shows the current time of day. To adjust time, press the arrow buttons.
The oven can be set to turn itself on and off. After the Auto ON/OFF Timer is set, the POWER ON OFF
button can be pressed to turn the oven off. This will not disrupt the AUTO ON/OFF setting. Electrical
power to the oven must remain on.
1. To set the oven to turn on, press and
hold the AUTO ON TIME button. The previously entered start
time will appear in the display. Use the UP and DOWN arrows to adjust the start time. Then
release the AUTO ON TIME button.
2. To set the oven to turn off, press and
hold the AUTO OFF TIME button. The previously entered
end time will appear in the display. Use the UP and DOWN arrows to adjust the end time. Then
release the AUTO ON TIME button.
3. To enable the automatic start, press and
hold the TIMER ON/OFF button until the indicator LED
to the right of the TIMER ON/OFF button is illuminated.
Backup Battery
The clock is backed up by a lithium battery which keeps the clock circuitry operating when all external
power is off. If the battery becomes low or dead while the external power is off, the display will read
12:00 (12 hr mode) or 0:00 (24 hr mode) and will not increment until a new time is set. The clock will
operate with a dead or missing battery, but must be set each time external power is turned on. Batteries
should be replaced when low or dead to avoid corrosive damage to the circuitry. Contact your local
Hobart Bakery Systems service office.