I N S T R U C T I O N S HCM61 & HCM62 FOOD PROCESSORS MODEL HCM61 HCM62 ML-134017 ML-134018 701 S. RIDGE AVENUE TROY, OHIO 45374-0001 937 332-3000 www.hobartcorp.com FORM 34468 (Apr.
Installation, Operation, and Care of HCM61 & HCM62 Food Processors SAVE THESE INSTRUCTIONS GENERAL The model HCM61 and HCM62 Food Processors are used for chopping meat, fish, fruits, vegetables, nuts, or dry bread, for mixing various sauces, mayonnaise, or soups, or for blending or pureeing various products, such as thickening or desserts. Refer to Capacity Recommendations, page 6. The HCM61 has a 1.5 HP motor, is provided with 120 Volt cord and plug, and requires a 20 Amp.
ELECTRICAL CONNECTIONS (Cord Connected Machines) WARNING: THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A GROUNDING TYPE PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG. Refer to the machine data plate and Electrical Data, below.
BOWL AND KNIFE ASSEMBLY ARM MOTOR SHAFT Install the Bowl so the center post of the Bowl fits over the motor shaft, one of the Bowl Pins fits in the slot at the front of the machine, and the bowl handles are positioned on left and right (Fig. 1). Install Knife Shaft over center bowl post so the slots on the Knife Shaft fit the grooves on the motor shaft (Fig. 1). KNIFE SHAFT BOWL HANDLE BOWL BOWL PIN SLOT PL-41421-1 Fig.
Fit the Bowl Cover over the Bowl Scraper so the center holes align. Fit the Scraper Handle Shaft through the center hole in the Bowl Cover into the Slots of the Bowl Scraper. The Bowl Cover Tab must fit around the 180° Cam on the Scraper Handle. The Tabs on the Scraper Handle Shaft must fit through the Slots in the center hole of the Bowl Scraper. SHAFT BOWL COVER TAB TAB 180° CAM SCRAPER HANDLE TS SLO BOWL COVER HANDLE PL-41424-1 Fig.
OPERATION WARNING: ROTATING KNIVES INSIDE. DO NOT OPEN COVER UNTIL KNIFE SHAFT STOPS. UNPLUG CORD BEFORE INSERTING OR REMOVING ATTACHMENTS, CLEANING OR SERVICING. CONTROLS O OFF P U LS E Model HCM61 OFF — Machine is OFF. Switch machine OFF before unpluging. ON — Runs motor and knife at 1700 rpm until switch is turned to OFF. N PULSE — Runs motor and knife at 1700 rpm while switch is held. When switch is released, machine returns to OFF. Model HCM62 — Machine is OFF.
PREPARING THE PRODUCT FOR PROCESSING Cut products such as meat and cheese into equal pieces of approximately 1" cubes for easy processing. For bread crumbs or other dry products, place product into the bowl first, turn the machine on, then add liquid ingredients. For pureeing products, be sure to move the Scraper Handle back and forth to reintroduce partially cut product into the cutting zone.
TROUBLESHOOTING PROBLEM Machine won't start. Machine stops while operating and won't restart. POSSIBLE CAUSE SUGGESTED CORRECTIVE ACTION Fuse or circuit breaker interrupting power. Have electrician check circuit. Bowl not in place. Make sure bowl is in proper position. Arm not in position over center of Bowl Cover. Make sure Arm is in proper position over center of Bowl Cover and Top of Core of Scraper Handle. Machine not plugged in. Plug into proper mating electrical receptacle.
