Food Processor User Manual

– 3 –
ELECTRICAL CONNECTIONS (Cord Connected Machines)
WARNING:
THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A GROUNDING TYPE
PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE. IF THE
RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT
REMOVE THE GROUNDING PRONG FROM THE PLUG.
Refer to the machine data plate and Electrical Data, below.
CHECK MOTOR ROTATION (Three-Phase Machines Only)
On model HCM62, check the rotation. With all parts in their normal operating positions (pages 4 – 5),
turn the switch to the Pulse position for two seconds and release. The direction of rotation of the knife
should be counterclockwise as viewed from the top.
If the knife rotates clockwise, correct the rotation using the following procedure:
DISCONNECT THE ELECTRICAL POWER SUPPLY. Interchange any two of the incoming power
supply leads in the plug. Reconnect the power supply and turn the switch to the Pulse position to
verify that the knife rotates counterclockwise as viewed from the top.
PRESTART CHECK
With the machine fully assembled (pages 4 – 5), make sure the cutting blades stop within 4 seconds
after the arm is swung back away from the center of the bowl cover.
Make sure the machine cannot be started with the bowl and cover removed but with the arm swung into
position above the center of the drive shaft.
If the machine fails to work properly, contact Service; do not allow the machine to be operated.
ATADLACIRTCELEATADLACIRTCELE
ATADLACIRTCELE
ATADLACIRTCELEATADLACIRTCELE
ledoMledoM
ledoM
ledoMledoMesahP/ztreH/stloVesahP/ztreH/stloV
esahP/ztreH/stloV
esahP/ztreH/stloVesahP/ztreH/stloV
yticapmAtiucriCmuminiMyticapmAtiucriCmuminiM
yticapmAtiucriCmuminiM
yticapmAtiucriCmuminiMyticapmAtiucriCmuminiM
eciveDevitcetorPmumixaMeciveDevitcetorPmumixaM
eciveDevitcetorPmumixaM
eciveDevitcetorPmumixaMeciveDevitcetorPmumixaM
SPMASPMA
SPMA
SPMASPMA
elcatpeceRelcatpeceR
elcatpeceR
elcatpeceRelcatpeceRgulPgulP
gulP
gulPgulP
16MCH1/06/02102
R02-5
P02-5:gulP
26MCH3/06/042-80202
R02-51L
P02-51L:gulP
.noitidetsetal,07APFN,edoClacirtcelElanoitaNehthtiwecnadroccanidelipmoC
G
W
X
G
Z
Y