GAS FRYERS WITH OR WITHOUT FILTER-IN-A-DRAWER Instructions Manual MODELS HGF35 ML-126994 HGF45 ML-126995 HGF65 ML-126996 HGF85 ML-126997 HGFD35 ML-126416 HGFD45 ML-126417 HGFD65 ML-126418 HGFD85 ML-126419 HGFC35 ML-126420 HGFC45 ML-126421 HGFC65 ML-126422 HGFC85 ML-126423 HGFD45 FORM 35614 (February 2004) HGF35F ML-135536 HGF45F ML-135537 HGF65F ML-135538 HGF85F ML-135539 HGD35F ML-126953 HGD45F ML-126956 HGD65F ML-126959 HGD85F ML-126962 HGC35F ML-126954 HGC45F ML-126957 HGC65F ML-126960 HGC85F ML-1

– 11 –

ASSEMBLY

When installed, the fryer must be restrained to prevent tipping to avoid the splashing of hot liquid. The

means of restraint may be the manner of installation, such as connection to a battery of appliances or

installing the fryer in an alcove, or by separate means, such as adequate ties.

Fryers Mounted on Legs (Non-Batteried Fryers)

Fryers serviced from the rear must have a minimum clearance of 18" (46 cm) from the wall when

mounted on legs.

1. Position fryer in an open space near the final installation area.

2. Tilt fryer on its side. Be careful not to scratch the finish.

3. Thread legs into mounting holes provided on bottom of fryer, then tighten.

4. Carefully raise fryer to its normal position.

Fryers Mounted on Casters

Separate instructions for installing casters to the fryer are included with the casters.

• For an appliance equipped with casters, instructions that (1) the installation shall be made with

a connector that complies with the Standard for

Connectors for Movable Gas Appliances, ANSI

Z21.69

Connectors for Moveable Gas Appliances, CAN/CGA-6.16

, and a quick-disconnect

device that complies with the Standard for

Quick-Disconnect Devices for Use With Gas Fuel,

ANSI Z21.41

, or

Quick Disconnect Devices for Use with Gas Fuel, CANI-6.9

, (2) adequate

means must be provided to limit the movement of the appliance.

• The fryer must be installed with a connector (not supplied by Hobart) in compliance with the

above code(s).

• The fryer must be installed with restraining means to guard against transmission of strain to the

connector, as specified in the strain relief manufacturer's instructions (Fig. 3).

• The fryer must be installed with the casters provided.

• Turn the gas supply off before disconnecting the restraint.

Fig. 3

REAR