LANtest Kit Operations Manual For 256551 LANtest Kit™ Hobbes GmbH Jacobsenweg 1 22525 Hamburg Germany
1 LANtest Kit CONTENTS INTRODUCTION................................................................................................................ 2 FEATURES ........................................................................................................................... 2 PACKAGE CONTENTS ..................................................................................................... 2 PRODUCT PROFILE.........................................................................................
2 LANtest Kit INTRODUCTION The LANTEST KIT Network Cable Tester is an innovative, practical tester that can easily read the correct pin configuration of 10BASE-T, 10BASE-2, RJ45/RJ11 modular, 258A, TIA-568A/568B and Token Ring cables by comparing one transmitting end to the corresponding receiving end. The included remote terminator allows the user to test installed cable either at a wall jack or a patch panel.
3 LANtest Kit PRODUCT PROFILE I. Loopback Test 1. 10Base-T Test 1.1 1.2 1.3 1.4 1.5 Plug one end of the tested cable into the transmitting RJ45 jack on the master unit marked with a ' ' and the other end of the cable into the remaining receiving RJ45 jack. Slide power switch on. The upper row of LEDs will start to scan in sequence if the Auto/Manual button is set on "Auto" mode. The LED for pin 1 will light up if the button is in "Manual" mode.
4 LANtest Kit 3.2 For the remaining testing procedures, please refer to steps 1.2 to 1.5 Note: 1. The center pin of BNC should be read on LED 2. 2. As Coaxial cable has only two wires, we suggest you read the result of the LED scan using Manual mode. II. Remote Test 1. Plug one end of the tested cable to the transmitting RJ45 jack on the master unit marked with a ' ' and plug the other end into the remote terminator.
