User's Manual

Turn on the transmitter and connect the battery to the Vusion. Perform a sensor

calibration as described in Maintenance Section to verify that the control board

is receiving signals from the receiver. The quadcopter will not enter the calibration

mode if the receiver is wired incorrectly.

Arm the motors by holding the yaw control to the right. Advance the throttle and

check for a motor not running. Bring the throttle back down to its lowest setting.

The motors should stop after 5 seconds.

MAINTENANCE

PROPELLER INSTALLATION

Please refer to this diagram when installing or replacing the propellers to make

sure each is installed on the correct motor.

CW – clockwise rotation when

viewed from above (there is an “A”

on the arms and the propellers).

CCW – counter clockwise rotation

when viewed from above (there is

a “B” on the arms and the propellers)

SENSOR CALIBRATION

1. Calibrate the sensors before the first flight. Turn on

the transmitter. Center all the trim adjustments. To center

the trim settings, hold down one side of the trim button

until you hear a long beep. If the controller stops

beeping, release the trim button and hold down the

other side.

2. Place the Vusion on a level surface and link the

quadcopter with the controller.

3. Press and hold the right stick in its lower right corner.

Move the left stick down and to the right. When the

LEDs on the Vusion start to flash, release both sticks. The

LEDs will stop flashing when the calibration is complete

CW PROP

FRONT

CCW PROP