User's Manual

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
FCC RADIATION EXPOSURE STATEMENT
FCC PRECAUTIONS
This device complies with part 15 of the FCC rules. Changes or modi cations not expressly
European 2014/35/EU Low Voltage Directive:
RISE 2.4GHz 6-Channel Tx Rx
; ETSI EN 301 489-1
BATTERY PRECAUTIONS
The RISE Vusion uses a lithium polymer (LiPo) battery. Follow these precautions
to ensure safe and trouble-free operation.
•
ALWAYS disconnect the battery from the quadcopter when not in use.
•
Do not attempt to use this charger with NiCd or NiMH battery packs.
•
Do not attempt to use a damaged battery.
•
This product contains a LiPo battery that must be recycled or disposed of properly.
•
Do not leave the charger unattended while charging. Disconnect the battery and
unplug the charger immediately if either becomes hot! However, it is normal for the
charger to get warm.
•
Disconnect the battery from the charger and carefully move the battery to a  reproof
location if the battery begins to swell or smoke!
•
Never allow the battery temperature to exceed 140° F [60° C].
•
Do not attempt to charge a battery if it is swollen or hot.
•
Do not place the charger or any battery on a  ammable surface or near combustible
materials while in use.
•
Never disassemble or modify pack wiring in any way or puncture cells.
•
Never charge inside a vehicle.
•
Always disconnect the battery and unplug the charger when not in use.
•
Land your model immediately when the LEDs  ash to indicate that the battery power
is low. Recharge the battery before attempting another  ight. A dangerous situation
can occur when attempting to recharge an over-discharged battery!
•
ALWAYS keep a supply of sand accessible when charging. Dumping sand on the
battery will extinguish a LiPo chemical  re.
•
ALWAYS KEEP OUT OF REACH OF CHILDREN
environment. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
approved by Tactic will void the user’s authority to operate this Tx. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help
RISE J2000 Transmitter FCC ID: IYFJ2000
CE COMPLIANCE INFORMATION
FOR THE EUROPEAN UNION
INSTRUCTIONS FOR DISPOSAL OF WASTE EQUIPMENT BY PRIVATE
USERS IN THE EUROPEAN UNION:
This symbol on the product or its packaging indicates this product must not be disposed of with
other household waste. Instead, it is the user’s responsibility to dispose of their waste equipment
by handing it over to a designated collection point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of your waste equipment at the time
of disposal will help to conserve natural resources and ensure that it is recycled in a manner that
protects human health and the environment. For more information about where you can drop
off your waste equipment for recycling, please contact your local city of ce, your household
waste disposal service or location where you purchased the product.
DECLARATION OF CONFORMITY:
Product:
Item number: RISJ2000 J2000
Equipment class: 1
J2000 transmitter: The objects of the declaration described here are in conformity
with the requirements of the speci cations listed below, following the provisions of the
EN 60950-1:2013 Safety
The objects of the declaration described here are in conformity with the requirements of
the speci cations listed below, following the provisions of the European R&TTE directive
1999/5/EC:
EN300 328 V1.9.1.
Technical requirements for radio equipment
ETSI EN 300 328 V1.9.1 (2015-02); ETSI EN 301 489-1
V1.9.2 (2011-09); ETSI EN 301 489-3 V1.6.1 (2013-08); EN
62479:2010 General EMC requirements for radio equipment
Product: RISE 5.8GHz 25mW VTx
Technical requirements for radio equipment
Hobbico, Inc.
2904 Research Road
Champaign, IL USA 61826
Distributed in Europe by Revell GmbH
D-32257 Bünde Germany
© 2016 RISE, a Hobbico company. RISE0200/05 Addn1MADE IN CHINA
™
RISE 25mW VTx FCC ID: IYF0205
V1.9.2 (2011-09); ETSI EN 301 489-3 V1.6.1 (2013-08); EN
62479:2010 General EMC requirements for radio equipment
ETSI EN 300 440-2 V1.4.1 (2010-08)
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority
to operate the equipment.