User's Manual

9
battery voltage drops to 10.5V. You should land the quadcopter as soon as
possible when you hear or see the alarm to avoid damaging the battery. The
Vusion will autoland when the battery voltage gets below 9.7V. The flight battery
should always be recharged before it is stored.
Warning: Your battery life will be reduced and the battery can be damaged
any time the battery voltage is below 9V. Charging a LiPo battery that is damaged
in any way can pose a fire hazard.
EXTERNAL RECEIVER
WARNING: Remove the props before connecting an external receiver to the Vusion.
The VUSION FPV RACER can be adapted to use an external receiver (one wire
for each channel) with the RISE2509 Cable Set. Note: The stock transmitter must
be used if recording photos or video by the on board DVR is desired.
The transmitter should have a new model set up using the following chart as a guide.
CHANNEL ASSIGNMENTS
MODEL TYPE: Airplane
NOTE: Spektrum/JR systems should have opposite directions.
Channel
Aileron
Elevator
Throttle
Rudder
Gear
AUX
Direction
normal
reverse
reverse
reverse
normal
reverse
Dual Rates
80/100
80/100
80/100
Expo
- 20/0
- 20/0
- 20/0
End Points
100/100
100/100
100/100
100/100
100/100
100/100
SWITCH ASSIGNMENTS - Ch 5
AUX
AUX
AUX
- 100%
0%
100%
Stability 1
Stability 2
Rate
If your transmitter can set failsafe values for all the channels, set the roll & pitch channels
to midstick and the throttle to its lowest setting to stop the motors. For transmitters that
only set failsafe on the throttle channel, set the throttle to its lowest setting.
1 Black
(Ground)
2 Red
(+5V)
3 White
4 Purple
5 Yellow
6 Green
7 Yellow
8 Black
Ground
+5V
Aux (CH 6)
Gear (CH 5)
Rudder
Throttle
Elevator
Aileron
RECEIVER
EXTERNAL RECEIVER CONNECTIONS
ADAPTER PLUG
Plug the 8 wire cable into the receiver as shown. Channel 6 must be assigned to
a switch so it can be used to change flight modes.