User's Manual

8
If the VTX must use a different FPV
channel, remove the rear cover
by pushing down on the edge of
the cover and sliding it back.
Tap the red button to cycle through
the 8 channels that are available.
To see current band, channel and
frequency on the monitor, select
Band E with the “B” button and
tap the CH button until the screen
displays the feed from the camera.
Flying FPV is more difficult than Line of Sight because it is difficult to determine altitude
with just the camera. Practice in an open area with a spotter. If possible, fly over tall
grass to minimize damage when you crash. When you are comfortable flying in an
open area, practice flying a pre-set course. This will help you learn to corner faster.
FAILSAFE/BEACON
The Vusion will autoland and start beeping when the signal from the transmitter
is lost. This feature can be used as a beacon to help locate the quadcopter when
it has crashed by turning off the transmitter.
VUSION CAMERA
Video clips and still images from the Vusion’s camera can saved to an on board
micro SD memory card (not included).
VIDEO
Pressing the video button will start and stop the video. The timer in the lower left
corner of the monitor will be on while video is being recorded. The DVR will
automatically save the video to the memory card every 4 minutes and start a new
video. To avoid losing any of the video after landing, always stop the recording
and wait 15 seconds before unplugging the battery from the Vusion.
STILL PHOTO
Pressing the “Picture” button will capture a still photo. The camera will not save
the photo if a video is being recorded.
BATTERIES
The VUSION FPV RACER uses a 1500mA 3 cell LiPo. Typical flight time is 5 to 8
minutes depending on the flying style.
The flight controller does have a low voltage cutoff to protect the LiPo from damage.
There is an alarm that will start beep and the rear LED panels will flash when the
Push