Instruction manual

6
❏
2. Slide the carbon wing joiner through the tube in the
high wing canopy hatch and center its position.
❏
3. Tighten the outer screws on the underside of the wing
panels. Loosen the inner screws.
❏
4. Install one of the wing panels onto the wing joiner tube.
Feed the aileron servo lead through the hole in the center of
the canopy hatch. The alignment pin fi ts into the small tube
pre-glued in the wing. Push the joiner tube into the wing until
it bottoms out against the outer screws in the wing panels.
❏
5. With both panels securely in place, tighten the inner
screws in the wing panels. Pull on the wing panels to confi rm
they won’t separate in fl ight.
❏
6. Attach the aileron servo leads to the Y-harness
connected to the receiver. Ensure the orange wires in the
servo leads align with the white wires in the Y-harness.