Instruction manual
BNF • RTF
Installing the Flight Battery and Arming The ESC
CAUTION: Always disconnect the Li-Po fl ight
battery from the aircraft receiver when not fl ying
to avoid over-discharging the battery. Batteries
discharged to a voltage lower than the lowest
approved voltage may become damaged, resulting
in loss of performance and potential fi re when
batteries are charged.
Range Test
Before each fl ying session, and especially with a new
model, you should perform a range check. Refer to your
transmitter manual for more information.
90 ft
(28 m)
IMPORTANT: The included AR636 receiver has been
programmed for operation only in this aircraft.
The included RTF transmitter should be bound to the
aircraft at the factory, but if you need to re-bind, follow
the binding procedure as shown.
You need to ‘bind’ your chosen Spektrum
™
DSM2
®
/
DSMX
®
technology equipped aircraft transmitter to the
receiver for proper operation. Please refer to the optional
parts list in this manual or visit www.bindnfl y.com for a
list of compatible transmitters.
Refer to your transmitter instructions for binding to a
receiver.
9
Binding Procedure Reference Table
1. Make sure the transmitter is powered off.
BIND PLUG
2. Make sure the transmitter controls are neutral, the
throttle and throttle trim are in the lowest position,
and the aircraft is immobile.
3. Install bind plug in the receiver bind port.
4. Connect the fl ight battery in the aircraft. The receiver
LED will begin to fl ash.
5. Power on the transmitter while holding the transmit-
ter bind button.
6. When the receiver binds to the transmitter, the light
on the receiver will turn solid. The motor will arm
with throttle and throttle trim at the lowest position.
7. Release the Bind button and remove the bind plug
from the receiver.
8. Disconnect the fl ight battery from the aircraft, then
power off the transmitter.
The receiver should retain the binding instructions received
from the transmitter until another binding is done.
Keep immobile and
out of the wind for
5 seconds
Transmitter Binding
F4U Corsair S EN
7