Operation Manual

03-3
Unhitching
1
2
3
• Release the overrun coupling so that the
gangway bellows
o
are expanded.
• Release the contact-breaking cable and pull
out the 13-pole plug.
• Slowly pull the lever upwards into position
k
to switch off the stabilizing device.
• Pull the lever backwards and, at the same
time, further into position
j
so that the
coupling opens.
• After the front landing wheel has been rotated
out, the caravan can be disconnected from
the base vehicle.
If you do not plan on using the cara-
van for a longer period of time, you
should store it with the ball coupling
closed.
6
4
3
Inspection of hitch
• The ball coupling is closed when the lever
rests in position
k
or
l
and the green pin
of the hitching display
m
is visible.
If the WS 3000 is not properly at tached
to the coupling ball, the caravan can
detach from the base vehicle.
Activation of the stabilization system
•
To activate the stabilization system, the
operation lever must be moved downward out
of the closed position
k
until it locks in
l
.
The spring corpus will become tense in the
process, so that contact pressure is created
on the coupling ball via the friction elements.
Afterward, the operation lever lies approxi-
mately parallel to the drawbar axle.
Shutoff of the stabilization system
• Bring the operation lever slowly upward into
the open position (position
k
) to shut off the
system.
Although it is possible to drive wi-
thout activating the stabilizing device,
e.g. when shunting, we do not re-
commend that you do so.