Operation Manual

10. Built-in devices
97
Hot water
The boiler can also be used even if it has not been lled with fresh
water.
1. No hot water. If you do not need hot water, press "-".
(The icon is empty).
3. More hot water. Should you need more hot water, you can tem-
porarily increase the water temperature to approx. 65 °C. Press
the plus key "+".
(The icon is full.
After 30 minutes, the hot-water heater will switch back to normal
operation. If you have selected more hot water, the circulation
pump will continue to operate.
2. Normal operation. If there is fresh water in the tank and you
would like to have hot water, press "+".
(The icon is half full.)
It is not possible to make any settings for hot water if
the daytime or nighttime automatic system is in ope-
ration and you have switched o the hot water. The
plus and minus icons are then greyed out.
If the "Operation" function for the pump has been set
to "Cont", you cannot select this.
If the "Operation" function for the pump has been set
to "Cont", the function "Permanent pump operation"
will be disabled for 30 minutes, but then returns to
permanent pump operation.
You do not need to make any settings if you only re-
quire hot water, for example in summer when no further
heating is required. The heating system will control this
function automatically.