Operation Manual

61
7. Installation of electrical devices
Normally, calibration is carried out automatically, whereby neither
thechargingnorthedischargecurrentmaybemorethan150mA.
The system can be manually calibrated
-whileusingthe230Vmainsoperationor
-ifnoelectricaldevicehasbeenswitchedonin12Voperation.
Todothis,the30Amainfusemustbeswitchedobypressingthe
button on the battery container (see “Operation via auxiliary bat-
tery”).Nowthesensorcancalibrateitself.Thisprocesstakesap-
prox.threehours.Ifthefuseisthenswitchedonagain,avalueof1
should be shown on the display.
Exitthemenusbyusingthe“Back”functionorautomaticallyafter
one minute.
Lighting system
Select the desired light in the menu for the lighting system by means
ofthecontrolknoborthearrowfunctions(display:yellow).Press
on the control knob or the left soft key to switch the corresponding
lightonoro(activatedlightsaredisplayedingreen).
Lichtsystem
09.01.2015
17:00 to 22:00
14:00 -------
01.07.15
-------
14:00 -------
01.07.15
-------
Lichtsystem
09.01.2015
17:00 to 22:00
14:00 -------
01.07.15
-------
14:00 -------
01.07.15
-------
On/O Timer
Access the submenu for programming the timer by means of the
timerfunction.Onlytheceilinglight(toprow)andtheoutertentlight
(bottomrow)canberegulatedusingthetimer.Activateordeacti-
vatethe“O”functionasappropriate.
Programming the timer
Trigger the desired value by means of the arrow keys or the control
knobandpressthe“On/O”functionorthecontrolknobtoselect
it. Turn the control knob or use the “+/-” functions to set the time.
Pressthecontrolknobagainorusethe“On/O”functiontoconrm
the set time.
Activating/deactivating the timer
The timer will only be activated if the function to the right is changed
from“O”to“On”(thewaytodothisisidenticaltoprogramming
thetimer).
Deactivatethetimerbysettingthefunctionfrom“On”backto“O”.
The activated timer is indicated in the main menu for
the lighting system by a blue dot in the corresponding
light icon.
Lichtsystem
10:00 to 14:30 on
0:00 to 0:00 off
14:00 -------
01.07.15
-------
14:00 -------
01.07.15
-------
•
Activated timer
(blue dot)
Exitthismenuby usingthe“Back”function; otherwise,afterone
minute, it will automatically switch back to the main menu on the
control panel.