Operation Manual

72
7. Installation of electrical devices
Connector pin assignment of the 13-pole plug („Jäger“ outlet)
Connector pins on 13-pole plug
("Jäger" system)
Operation via base vehicle
During the drive, the battery of the base vehicle takes over the
supplyofthe12Vdevicesifcontact9ofthe13-polesocketsys-
tem on the base vehicle has been equipped.
Usethemainswitchonthecontrolpaneltoswitchothe12V
operation during the drive, on longer stopovers and breaks to
conserve power in the base vehicle‘s battery.
When running on 12 volts, the refrigerator only functions if the
motorofthebasevehicleisturnedon.Contacts10and11ofthe
13-polesocketsystem.
Alwaysswitchotheelectricconnectionbetweenthe
base vehicle and the caravan before hooking the cara-
van up to a low-voltage supply.
Ifoperationiscarriedoutviathebasevehicle,amaxi-
mum of 2 electrical devices in the caravan can be swit-
chedatthesametimeusingthecontrolpanel(exception:
theself-sucientpackagehasbeeninstalled).
PIN Colour of
conductor
Cross
section
Electrical
devices
1 yellow 1,5 Left blinker
2 blue 1,5 Fog tail lamp
3 white 2,5 Mass (1-8)
4 green 1,5 Right blinker
5 brown 1,5 Right light
6 red 1,5 Brake light
7 black 1,5 Left light
8 orange 1,5 Back-up light
9 blue 2,5 Steady plus
10 blue/white 2,5 'Plus' ignition
11 white/red 2,5 Mass (10)
12 violet 1,5 Camper licence plate
13 white/blue 2,5 Mass (9)