Operation Manual

10. Built-in devices

• Open the valve on the gas bottle and the gas shuto valve on

the gas pipe.

• Turn the operation handle

to the thermo-stat position 1-10.

• Press the operation handle

down until it locks. The ignition

is automatic from this position, until the ame burns. The igni-

tion spark is audible. The control light on the automatic ignitor

blinks during ignition.

• Hold the operation handle in for up to 10 seconds, so that the

ignition fuse kicks in.

• If the gas line is lled with air, it can take up to a minute until the

gas is ready to burn. Hold the operation lever

in during this

period, until the ame burns.

To operate

Due to its design, the radiator cover gets hot when the

heating is on. The operator is responsible for exercising

due diligence so that third parties (especially small

children) are not hurt.

Should there be any diculty, please wait at least 3

minutes before re-attempting ignition; otherwise, there is

a danger of explosion.

• If the ame goes out again, it will immediately be re-ignited

during the closing time of the safety pilot (approx. 30 seconds).

• If no ame is ignited, the automatic ignitor will continue to work

until the operation handle

is switched to “0”.

To shut o

• Turn the operation handle

to position "0". The automatic

ignitor is thereby shut o.

• Switch o the fan (set the rotary switch to "0").

• Close the bottle valve and the quick-close valve if the unit is not

used for a longer period of time.

During initial operation of the heating system, the-

re will be a slight nuisance caused by smoke and

odours. Immediately turn the operating handle

the heating to position „5“ and set the circulation fan

to the highest position. Open all doors and windows

and air the caravan well. The smoke and odours will

disperse after a short while.

Knob with thermostat and ignition