Operation Manual

Maintenance and Care
11-7
Draining the lter housing of the fresh water pump:
You will often nd water deposits in the lter housing of the
fresh water pump. To protect against the formation of dirt
as well as frost, this housing should be dried thoroughly
before longer breaks or when winter starts.
• Unscrew the lter housing (only the transparent housing!)
j
from the lter of the fresh water pump.
• Thoroughly remove the water from the lter and allow the
lter to dry completely.
• Then reattach the lter.
1
The following applies for tanks and containers:
• Empty and clean the fresh water tank.
• Empty and clean the waste water tank.
• Empty and clean the toilet tank.
• Completely empty the hot-water boiler: use the control
panel to switch off the electric power supply and open all
of the water taps.
• Shut the main stop valve on the gas cylinder as well as all
separate gas stop valves. Always take the gas cylinders
out of the gas bottle container, even if they are empty.
Also note the information and operating instructions given
by the manufacturers of the built-in equipment.